18 Jan

H31-121-ENU Huawei Certified Network Professional – BCAN (Carrier IP)

Please prepare for H31-121-ENU Huawei Certified Network Professional – BCAN (Carrier IP) exam with real Huawei H31-121 HCNP-BCAN (Carrier IP) exam questions. We ensure you pass HCNP-BCAN (Carrier IP) Certification H31-121 exam smoothly. Here we recommend you test Huawei HCNP-BCAN (Carrier IP) H31-121-ENU Free Online Test first.

We will provide 7 questions for this HCNP-BCAN H31-121-ENU Certification exam. You can get 14 points after answer one question correctly. All the questions we provide are the latest exam subjects. They are just part of the full version 314 questions. And all your real questions will be randomly chosen from our dumps. If you want to purchase the full version 314 questions please go to our Shop page or click “I want to buy full version“. Just leave your message here or contact us via email hcdatest@outlook.com if you have any questions.

Start to test:

When Host A checks ARP table, as follows:
Interface: 1.1.1.2 — 0x2
Internet Address Physical Address Type
1.1.1.1 00-e0-fc-00-00-02 dynamic
1.1.1.15 00-e0-fc-00-00-02 dynamic
It means the NIC in this 00-e0-fc-00-00-02 device configures two different IP addresses.

 
 

The following about Eth-trunk, which active interface preemption function is correct?

 
 
 
 

From which packet is PPPoE’s Session ID obtained?

 
 
 
 

Which of the following command is used to configure and send flush packet?

 
 
 
 

On Switch A, enter the following configuration:
[SWA] stp enable
[SWA] stp mode mstp
[SWA] stp region-configuration
[SWA-mst-region] region-name RegionA
[SWA-mst-region] revlsion-level1
[SWA-mst-region] instance 1 vlan 2
[SWA-mst-region] instance 2 vlan 3
[SWA-mst-region] quit
The what the number of the instance is does vlan2 corresponding to?

 
 
 
 

The configuration of Port GigabitEthernet0/0/ is as follows:
Which vlan’s data can go through the port?
#
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 4
#

 
 
 
 

the information that S9300 check is as follows: is this smart-link group’s status is normal? Why?
Display smart-link group 1
Smart Link group 1 information:
Smart Link group was enabled
Wtr-time is: 30 sec.
Load-Balance Instance: 10
There is no protected-VLAN reference-instance
DeviceID: 0018-2000-0083 Control-VLAN ID: 0
Member Role State Flush Count Last-Flush-Time
——————————————————————————-
GigabitEthernet1/0/1 Master Active 10 2009/01/05 10:33:96 UTC+05:00
GigabitEthernet1/0/2 Slave Inactive 10 0000/00/00 00:00:00 UTC+05:00

 
 
 
 

Question 1 of 7

buy

Leave a Reply


Recent Posts


Tags

H11-851-ENU exam dumps H12-211-ENU H12-211-ENU exam dumps H12-211-ENU practice test H12-221-ENU H12-222 H12-222-ENU H12-222-ENU exam dumps H12-222-ENU exam questions H12-223 H12-223-ENU H12-223-ENU exam dumps H12-223-ENU questions and answers H12-261-ENU H12-261-ENU exam dumps H12-261-ENU questions and answers H12-711-ENU practice test H13-611-ENU H13-611-ENU exam dumps H13-621-ENU Exam dumps H13-622-ENU h13-623 H13-623-ENU H13-623-ENU exam dumps H19-301-ENU exam dumps H19-307-enu H19-307-ENU exam questions H19-307-ENU questions and answers H31-122-ENU H31-211-ENU H31-211-ENU exam dumps H31-311-ENU HCDA HCDA (Carrier IP) HCIE-R&S HCNA HCNA-Security HCNA-Storage-BSSN HCNA Storage HCNP HCNP-R&S-IENP HCNP-Storage HCNP-Storage-CBDS hcnp R&S Video Conference