Tag Archives: H35-581_V2.0-ENU

23 Dec

Read H35-581_V2.0-ENU Free Demo Questions – Verify the HCIP-5G-RNP&RNO V2.0 Certification Exam Questions

Obtaining the HCIP-5G-RNP&RNO certification to prove your skills and enhance your career is highly recommended. When planning to earn this certification, you must register for the H35-581_V2.0-ENU exam and achieve success. HCDAtest has the latest Huawei H35-581_V2.0-ENU exam questions for your learning. 

To ensure your success and obtain the desired HCIP-5G-RNP&RNO V2.0 certification, it is essential to have the necessary study materials and resources. HCDAtest has recently launched the highly anticipated HCIP-5G-RNP&RNO V2.0 H35-581_V2.0-ENU exam questions, which comprehensively cover all the exam objectives. By utilizing these HCIP-5G-RNP&RNO V2.0 questions and answers, you will gain access to a wealth of knowledge and information that will greatly enhance your exam preparation. With the assistance of HCDAtest, you can confidently approach the exam and increase your chances of passing with outstanding results. Free demo questions for the H35-581_V2.0-ENU exam are available online for you to check.

Begin to Test:

1. Under the Option3x architecture, during the dual connection establishment process, the eNB will send an ERAB Modify IND message to the MME. Which network element does the IP address carried in the message belong to?

Question 1 of 33

2. Regarding the SgNB release process under EN-DC, which of the following statements is wrong?

Question 2 of 33

3. Regarding the description of the SSB physical cycle, which of the following descriptions is wrong?

Question 3 of 33

4. Regarding the switching mechanism of BWP, which of the following descriptions is wrong?

Question 4 of 33

5. Regarding SSB measurement, which of the following descriptions is correct?

Question 5 of 33

6. Which of the following is not the possible bandwidth of CORESETO?

Question 6 of 33

7. In the inter-frequency switching scenario based on frequency priority, which of the following event measurement reports is used to trigger inter-frequency measurement?

Question 7 of 33

8. If SRS does not support independent power control, then the power control command of SRS is the same as which of the following channels?

Question 8 of 33

9. Which of the following is the first step in the downlink beamforming process?

Question 9 of 33

10. In the PDCCH CCE aggregation level adjustment algorithm, which of the following parameters does gNB use as input?

Question 10 of 33

11. After NSA high load protection is turned on, which of the following option descriptions is correct?

Question 11 of 33

12. Which of the following KPI indicators cannot be counted based on the community?

Question 12 of 33

13. In the NSA networking scenario, which of the following neighbor cells does not require planning?

Question 13 of 33

14. Regarding 5G DRX parameter configuration, which description is wrong?

Question 14 of 33

15. In Huawei base stations, what is the minimum aggregation level of PDCCH CCE?

Question 15 of 33

16. How many bits are the uplink power control commands in 5G?

Question 16 of 33

17. In CA, SCELL changes are triggered by which of the following events?

Question 17 of 33

18. In Huawei gNB, which protocol layer is the traffic statistics indicator based on?

Question 18 of 33

19. If SCG addition based on traffic volume is enabled, which protocol layer's service measurement is used to trigger by eNodeB?

Question 19 of 33

20. Which of the following NSA frequency band combinations may have second-order intermodulation interference?

Question 20 of 33

21. Regarding UE access on the 5G side in the NSA scenario, which of the following descriptions is wrong?

Question 21 of 33

22. In a low-frequency scenario, how does the UE obtain the beam ID of the current SSB?

Question 22 of 33

23. Under the Opiton3x architecture, if the SgNB addition process is triggered, a maximum of how many tunnels will be established on the X2-U interface?

Question 23 of 33

24. Which of the following BWPs is at the community level?

Question 24 of 33

25. When 4 downlink streams are used, which of the following configuration schemes for PDSCH DMRS has the highest overhead?

Question 25 of 33

26. In 100MHz, 30KHz, SCS network, what is the maximum bandwidth of SRS?

Question 26 of 33

27. Which of the following reference signal positions is related to PCI?

Question 27 of 33

28. In the RRC Inactive state, what is the scope of the UE paging message?

Question 28 of 33

29. Regarding the description of PDSCH and PUSCH, which of the following descriptions is wrong?

Question 29 of 33

30. For the public PDCCH space, what is the minimum CCE format?

Question 30 of 33

31. What is the maximum number of PRBs contained in 1 RBG?

Question 31 of 33

32. Which of the following formats PUCCH does not have DMRS?

Question 32 of 33

33. Which of the following is a physical layer processing step unique to the DTF-S-OFDM waveform?

Question 33 of 33


 


Recent Posts


Tags

H12-211-ENU H12-211-ENU online test H12-211-ENU practice test H12-221 H12-221-ENU H12-221-ENU online test H12-222 H12-222-ENU H12-223 H12-223-ENU H12-261 H12-261-ENU H12-261-ENU online test H12-261-ENU practice test H12-261-ENU questions and answers H12-311-ENU H13-511-ENU H13-511-ENU exam dumps H13-511-ENU latest dumps H13-511-ENU questions and answers H13-511-ENU real exam questions H13-511-ENU real questions H13-511-ENU test prep H13-511-ENU training materials H13-611-ENU H13-623-ENU exam dumps H13-629-enu H19-301-ENU exam dumps H19-307-enu H19-308 H19-308-ENU H19-308-ENU exam dumps H31-211-ENU H31-211-ENU exam dumps HCDA (Carrier IP) HCNA HCNA-Cloud-BCCP HCNA-HNTD HCNA Storage HCNP HCNP-R&S-IENP HCNP-Storage Huawei Certified Internetwork Expert-Routing & Switching Huawei Certified Network Associate-Building Cloud Computing Platform Video Conference